Composite & uPVC Door Spraying
Key Features
-
Kolorbond K2 paint
-
Grain effects will show through the new colour
-
Looks like a factory finish
-
Handles removed for spraying
-
Kolorbond paint with UV protection
-
Choose any colour from all standard colour charts (RAL, BS) and most decorative colour ranges
-
Matt, satin & gloss finishes available
-
One-day turnaround
-
10-year guarantee
-
Save up to 80%
Our Spraying Process
Cleaning & Degreasing
We clean the substrate using Vinylkleen and Scotchbrites which lightly abrade the surface.
This stage removes all water-soluble contaminants and most oils.
Next we thoroughly clean the profile surface again using Windowprep and a clean white cloth.
Stage 2
Spraying
Next, we use specialist materials to remove any dust or swarf remaining on the surface of the profile.
We then spray the profile with a dust coat and check for any contamination before proceeding to spray a full coat.
We allow this to flash off then inspect for inclusions. If any are identified, we remove them with sand paper and apply a further coat.
Stage 4
Unmasking & Re-sealing
Finally, we unmask all surfaces and re-seal where silicone has been removed from the profile with a new, colour-coded silicone.
Stage 1
Masking
This is the most time-consuming part of the job.
During this stage we cover all surrounding surfaces of the profile that don't require painting to protect them from any overspray.
Stage 3
Quality Check
Once spraying is complete, before we unmask the profile, an inspection across all painted surfaces is carried out.
This is to ensure we have a flawless finish and no touch ups are needed.
Stage 5
Small Details, Factory Finish
Use the hotspots on the images below for a visual guide on the smaller details we pay close attention to when completing each project.
No Brush Marks
No Brush Marks
Keep Effect
Smooth Finish
Two Tone
Smooth & Shiny